Factory Settings - NETGEAR WNR2000v4 User Manual

Factory Settings

You can return the router to its factory settings. Use the end of a paper clip or some other
similar object to press and hold the Restore Factory Settings
the router for at least 7 seconds. The router resets, and returns to the factory settings. Your
device returns to the factory configuration settings that are shown in the following table.
Table 4. WNR2000v4 router factory default settings
Feature
Router login User login URL
User name (case-sensitive)
Login password (case-sensitive)
Internet WAN MAC address
connection
WAN MTU size
Port speed
Local area LAN IP
network (LAN)
Subnet mask
DHCP server
DHCP range
Time zone
Time zone daylight saving time
Wireless Wireless communication
SSID name
Network key (password)
Broadcast SSID
Transmission speed
Country/region
RF channel
Operating mode
N300 Wireless Router WNR2000v4
Default behavior
www.routerlogin.com or www.routerlogin.net
admin
password
Use default hardware address
1500
Autosensing
192.168.1.1
255.255.255.0
Enabled
192.168.1.2 to 192.168.1.254
United States is Pacific time; otherwise, varies by region
Disabled
Enabled
Preset. For information, see the router label. (For a
description of the router label, see
Enabled
Auto
Note:
IEEE Standard 802.11 specifications. Actual throughput
varies. Network conditions and environmental factors,
including volume of network traffic, building materials and
construction, and network overhead, lower actual data
throughput rate.
United States in the US; otherwise varies by region
Auto
Up to 150 Mbps
Supplemental Information
136
button on the back panel of
The maximum wireless signal rate derived from
Label on page 12.)