Router Setup Preparation; Use Standard Tcp/Ip Properties For Dhcp; Gather Isp Information; Wireless Devices And Security Settings - NETGEAR WNR2000v4 User Manual

Router Setup Preparation

You can set up your router with NETGEAR genie automatically, or you can use the genie
menus and screens to set up your router manually. However, before you start the setup
process, you need to have your ISP information on hand and make sure the laptops,
computers, and other devices in the network have the settings described here.

Use Standard TCP/IP Properties for DHCP

If you set up your computer to use a static IP address, you need to change the settings so
that it uses Dynamic Host Configuration Protocol (DHCP).

Gather ISP Information

If you have DSL broadband service, you might need the following information to set up your
router and to check that your Internet configuration is correct. Your Internet service provider
(ISP) should have provided you with all of the information needed to connect to the Internet.
If you cannot locate this information, ask your ISP to provide it. When your Internet
connection is working, you no longer need to launch the ISP's login program on your
computer to access the Internet. When you start an Internet application, your router
automatically logs you in.
• The ISP configuration information for your DSL account
• ISP login name and password
• Fixed or static IP address settings (special deployment by ISP; this is rare)

Wireless Devices and Security Settings

Make sure that the wireless device or computer that you are using supports WPA or WPA2
wireless security, which is the wireless security supported by the router. For information
about the router's preconfigured security settings, see

Types of Logins and Access

There are separate types of logins that have different purposes. It is important that you
understand the difference so that you know which login to use when.
• Router login logs you in to the router user interface from NETGEAR genie. For more
information, see
• ISP login logs you in to your Internet service. Your service provider has provided you
with this login information in a letter or some other way. If you cannot find this login
information, contact your service provider.
• Wireless network login. Your router is preset with a unique wireless network name
(SSID) and password for wireless access. This information is on the label located on the
back of your router.
N300 Wireless Router WNR2000v4
Use NETGEAR genie after Installation
Getting Started with NETGEAR genie
Basic Wireless Settings
on page 18.
17
on page 27.