Panasonic SA-PT150GCP Service Manual page 31

8.3.2. DVD Module Error Code Table
Error
Diagnosis Contents
Code
U702 DVD/DVI I2C
communication error when connecting it with DVD/
U703 DVD/DVI attestation
error
U704 DVD/DVI SRM
Riborcerar
U705 DVD/DVI SRM disk
falsification check
error
F740 DVD device key
F893 FLASH ROM IC data Firmware error, DV5.0 LSI IC (IC8651)
falsification error
F894 EEPROM IC
abnormality error
F895 Language area
abnormal
F896 No existence model
F897 Initialization
error
F898 Disagreement of
hardware and
software
F899 The communication
specification
disagreement
between
micro-processor
Description of error
The communication error of I2C
DVI. For instance, when EDID
information to which information on the
TV set side has been described
cannot be read, it is generated.
When attestation (HDCP) with the TV
side fails when connecting it with
DVD/DVI, it is generated.
It is generated at the equipment to
which the TV set is Riborced when
connecting it with DVD/DVI.
It is generated at the time of it is time
when illegal the SRM data of the
reproducing disk (verify error), when
connecting it with DVD/DVI.
I2C error when writing DVD Key
device into transmitter.
error.
When failing in the access to
EEPROM IC located in the DVD
Module P.C.B. (IC8611)
Firmware version agreement check for
factory preset setting failure
prevention.
Firmware version agreement check for
factory preset setting failure
prevention.
Incomplete initialization after writing of
new firmware (Factory preset setting
failure prevention)
Unsuitable combination of AV Decoder,
SDRAM & FLASH ROM IC (firmware).
Unsuitable combination of number of
system com and panel com used.
(Frimware)
SA-PT150GC / SA-PT150GCP / SA-PT150GCS / SA-PT150GCT / SA-PT150GS
Automatic FL Display
31
Remarks
Press [ STOP] on
main unit for next error.
Press [ STOP] on
main unit for next error.
Press [ STOP] on
main unit for next error.
Press [ STOP] on
main unit for next error.
Press [ STOP] on
main unit for next error.
Press [ STOP] on
main unit for next error.
Press [ STOP] on
main unit for next error.
Press [ STOP] on
main unit for next error.
Press [ STOP] on
main unit for next error.
Press [ STOP] on
main unit for next error.
Press [ STOP] on
main unit for next error.
Press [ STOP] on
main unit for next error.