Attach Handle - Hoover 4600 Owner's Manual

1-10
N

Attach handle

With cord hooks to the back, place
assembled handle onto handle base of
cleaner body (N).
Rock handle side to side while push-
ing down firmly. Extra pushing effort
may be required.
1-13
Attach tool rack
With side of rack marked TOP FRONT fac-
ing away from cleaner handle, pull cord
through rack and lower rack over handle
as shown. Slide rack down handle.
1-16
Attach bag
compartment
Pull bag door latch forward and remove
door. Set bag door aside.
1-11
Push bolt into hole on lower front of handle.
If bolt will not go through hole easily,
check the following:
• the bracket is properly positioned (Fig.
1-9)
• the handle is pushed completely down
(Fig. 1-10)
1-14
O
Continue to slide rack down until bottom of
rack is below lower cord hook (O). Snap
one side of rack then the other onto lower
handle.
1-17
Slide large tab (R) on bottom back of bag
compartment into slot between the bracket
and the lower handle.
1-12
Place nut in recessed area at back of
handle. Hold nut in place while tightening
bolt securely with a screwdriver.
Note: Only one nut is needed on this
model. The extra nut is not required but
has been provided for your convenience.
1-15
Slide rack down handle until upper hooks
(P) snap into slots (Q) on handle.
1-18
R
S
Note round opening and hooks (S) on
back of bag compartment. Place opening
over dirt tube (T) and align hooks with slots
in handle.
Push very firmly to snap both hooks
into handle.
Pull on bag compartment to make sure it is
completely snapped to handle.
P
Q
T
Continued
5