Electrical Plug Connections; Preparation Of The Dryer; Dryer Maintenance - LG DLEC733W Training Manual

Caution: Improper connection of the equipment grounding conductor can result in a risk of electric
shock. Check with a qualified electrician or a service person if you are in doubt as to whether
the dryer is properly grounded.

ELECTRICAL PLUG CONNECTIONS

Following are several warnings and instructions concerning making the electrical connection for
electric dryers. Use power supply (Socket) rated at 230 Volts at 15 amps.
CAUTION: Do not plug with several other appliances power cord. Do not grasp power cord or switch
with wet hands. Do not use damaged power cord, plug and socket.

PREPARATION OF THE DRYER

Prior to the first use of this appliance, use all-purpose cleaning products or a solution of detergent
and water, with damp clothes to remove from the inside of the dryer drum any dust or dirt that may
have accumulated in the inside of the dryer. Plug-in your dryer after reviewing the following parts on
your dryer's Electrical Requirements.

DRYER MAINTENANCE

1) After one year of use or if drying performance decreases, the interior and complete exhaust system
of the dryer should be examined and cleaned if necessary.
2) Check the weather hoods frequently to ensure the dampers are moving freely, that the dampers are
not pushed in and that nothing has been set against the dampers.
3) A qualified service person or company should be used to perform this maintenance.
4) Ordinarily, the dryer drum will need no care. Wipe the exterior of the dryer as required, and always
immediately wipe the exterior of the dryer in the event any detergent, bleach, or other washing
products is spilled on the dryer, because these products may cause permanent damage to the exterior
finish of the dryer.
5) Clean the control panel with a damp cloth as necessary. Warning: spray pre-wash products may
damage the finish of the control panel.
6) Please clean the lint filter either before or after drying each load.
7) Always make sure the lint filter is clean before starting a new load, because a clogged lint filter
may increase drying times.
8) Please note that the wiring diagram is provided inside the dryer Top Plate. Label all wires prior to
disconnection when servicing the dryer, because wiring errors can cause serious injury to you and your
dryer.
Series 33 Dryer Training
9
INSTALLATION
Installation