Installation; Level The Dryer; Position The Dryer - LG DLEC733W Training Manual

INSTALLATION

Usually, the technician will be called to service a machine that has already been installed by someone
who has been specifically trained for that task. It is important, however, that the servicer be familiar
with installation procedures and able to determine whether a particular problem is a product defect
or the result of poor installation. The following pages describe an installation and operation check.

LEVEL THE DRYER

Leveling the dryer is to prevent undesirable noise and vibration. Place
your dryer in a solid and level area where water is not dripping or
freezing. If the dryer is not level, adjust the leveling legs up and down
as necessary. Turn them clockwise to raise and counterclockwise to lower
until the dryer is not wobbling both front-to-back and side-to-side.

POSITION THE DRYER

Choose a location with a solid floor for your dryer. Place the
dryer at least eighteen inches above the floor for a garage
installation. After placing the dryer in the desired location, please
make sure that it has the required clearances shown below.
Leveling legs should be secured. All four legs are stably placed
on the solid and even floor. If dryer is not level, laundry may
not tumble properly and sensor will not detect the accurate
humidity information. When adjusting leveling, please be cautious
not to have serious injuries on your fingers and toes.
Certain minimum clearances are required behind and to the
sides of the unit, as shown. Consider space needed for companion
appliances and allow additional clearance for installation and
servicing.
Series 33 Dryer Training
When pushing down the
opposite corners of the
machine, the machine should
not move. (Please, check both
directions) If machine rocks
when pushing the machine top
plate diagonally, adjust the feet
again.
7
INSTALLATION
32.5"
(82.5 cm)
23.4"
(59.5 cm)
41.9"
(106.4 cm)
23.6"
(60.0 cm)
Installation