F12- Efx; F13- Equalizer Page-15; F14- Damper Physical Model Page-15; F16- Power Led Page-15 - GEM Prp700 Owner's Manual

owners manual

F12- EFX

This menu allows you to edit the different effect type parameters.
Select F12 using the
Press the
SELECT/TEMPO buttons
function button
Function button Press again
fl ashes
F13- Equalizer
This menu turns ON or OFF the piano internal equalizer.
Press the Select F13 using the SELECT/TEMPO
functions button
F14- Damper physical model
This menu enables or disables the piano internal Damper Physical Modeling.
Press the Select F14 using the SELECT/TEMPO
functions button
F15- Decay Env.
This new function enables you to select two different modes for the damper pedal for the decay of
strings, pads, organs etc. sounds. If using dual sounds (piano+strings) for example, you can select
DECAY ENV. ON (which is the factory default), allowing the non piano sound to decay at a pre de-
termined decay envelope. By turning this feature to OFF , the Strings, (Pads, Organ etc.) will remain
"held" until you release the damper pedal.
Press the Select F15 using the SELECT/TEMPO
functions button
F16- Power LED
Set ON or OFF the power LED located under the piano music rack
Press the Select F16 using the SELECT/TEMPO
functions button
The function
button fl ashes
DEPTH
PARAM1
PARAM2
buttons
Pressing the DATA button the display shows
buttons
Pressing the DATA button the display shows
buttons
Pressing the DATA button you can switch ON
buttons
CHORUS
The display shows the
Press again current effect selected
for editing (CHORUS by
default)
VALUE RANGE
BALANCE
Select the Edit the
parameter to edit parameter value
using the SELECT using DATA +/-
buttons buttons
BALANCE
DATA
Pressing the DATA button the display shows
the current value (ON by default).
BALANCE
DATA
the current value (ON by default).
BALANCE
DATA
the current value (ON by default).
BALANCE
DATA
(default) or OFF the power led lighting
Prp700-Prp800
PHASER
TREMOLO
DELAY
DATA
Select effect type using the
SELECT buttons
Set OFF using the DATA
buttons.
Set OFF using the DATA
buttons.
Set OFF using the DATA
buttons.
Selecting the DEMO
button on the panel the
Power LED will be set ON
Page15