Error Code Table - Sharp AM-900 Service Manual

[4] Error code table

1. Communication error code table
1.1. G3 Transmission
Code Final received signal
0 Incomplete signal frame
1 NSF, DIS
2 CFR
3 FTT
4 MCF
5 PIP or PIN
6 RTN or RTP
7 No signal or DCN
8 -
11 -
12 -
13 -
1.2. G3 Reception
Code Final received signal
0 Incomplete signal frame
1 NSS, DCS
2 NSC, DTC
3 EOP
4 EOM
5 MPS
6 PR1-Q
7 No signal or DCN
8 -
9 -
10 -
11 -
12 -
13 -
1.3. Super G3 mode
Error Code Transmission Errors
E-16 Same as E-0
E-17 Same as E-1
E-18 Same as E-2
E-19 -
E-20 Same as E-4
E-21 -
E-22 -
E-23 Same as E-7
E-24 Same as E-8
E-25 Same as E-11
E-26 Same as E-12
E-27 Same as E-13
E-28 -
E-29
Error occurred during handshaking for super G3
E-30
mode
E-31
Cannot recognize bit stream after flag
Cannot recognize DCS signal by echo etc.
Cannot recognize NSS signal (FIF code etc.)
Disconnects line during reception (carrier missing etc.)
Disconnects line by fall back
Disconnects line during reception of multi page
Cannot recognize NSS, DCS signal in the case of mode change
The line is hung up without replying to telephone request from the receiving party.
Cannot recognize NSS, DCS signal after transmit RTN or RTP signal.
No response in receiver side or DCN signal received* (transmitter side)
Owing to error in some page the error could not be corrected although the specified number of
error retransmissions were attempted.
Error occurred after or while reception by the remote (receiving) machine was revealed to be
impossible.
Error occurred just after fallback.
Error occurred after a response to retransmission end command was received.
Cannot recognize bit stream after flag
Cannot recognize CFR or FTT signal
Disconnects line during transmission (line error)
Cannot recognize NSS signal (FIF code etc.)
Cannot recognize MCF, PIP, PIN, RTN, RTP signal
Cannot recognize MCF, PIP, PIN, RTN, RTP signal in the case of mode change
The line is hung up without replying to communication request.
Cannot recognize PIP, PIN signal in the case of TALK request
No response in transmitter (cannot recognize DIS signal) or DCN signal received* (receiver side)
Error occurred upon completion of reception of all pages.
Error occurred when mode was changed or Transmission/Reception switching was performed.
Error occurred during partial page or physical page reception.
Error occurred after or during inquiry from the remote (transmitting) machine as to whether recep-
tion is possible or not.
Error occurred during or just after fallback.
Error occurred after the retransmission end command was received.
Reception Errors
Same as E-0
Same as E-1
Same as E-2
Same as E-8
Same as E-9
Same as E-10
-
Same as E-7
-
Same as E-11
Same as E-12
Same as E-13
-
2 – 31
Error Condition (Receiver side)
Error Condition (Receiver side)
1.4. <Reference> Details of E-29 ~ E31
E-29 Handshaking error in V.8 negotiation procedure
E-30 Handshaking error in V.34 line probing procedure
E-31 Handshaking error in V.34 HDX training procedure
AM-900U