Advertisement
7) Close the front cover and then the side cover by pressing
the round projections near the side cover open button.
6. LOADING COPY PAPER (installing the
paper tray)
1) Raise the handle of the paper tray and pull the paper tray
out until it stops.
2) Remove the pressure plate lock. Rotate the pressure plate
lock in the direction of the arrow to remove it while pressing
down the pressure plate of the paper tray.
3) Store the pressure plate lock which has been removed in
step 2 and the screw which has been removed when un-
packing (see page 4-2, step 2 of REMOVING PROTEC-
TIVE PACKING MATERIALS) in the front of the paper tray.
To store the pressure plate lock, rotate the lock to fix it on
the relevant location.
Pressure plate lock
Screw
4-3
4) Adjust the paper guides on the paper tray to the copy paper
width and length. Squeeze the lever of paper guide (A) and
slide the guide to match with the width of the paper.
Move paper guide (B) to the appropriate slot as marked on
the tray.
Paper guide (B)
5) Fan the copy paper and insert it into the tray. Make sure the
edges go under the corner hooks.
6) Gently push the paper tray back into the copier.
7. POWER TO COPIER
1) Ensure that the power switch of the copier is in the OFF
position. Insert the attached power cord into the power cord
socket at the rear of the copier.
2) Plug the other end of the power cord into the nearest outlet.
AL-1250
Paper guide (A)
Advertisement
