Memory Locations - Cobra CXT1035 FLT CAMO Owner's Manual

Mode Functions
Operation

10 Memory Locations

Your microTALK radio has 10 Memory Locations for storing
your most frequently used channels and channel/privacy code
combinations. These Memory Locations can be selected individually or
can be scanned.
To program a memory location:
MEM/ESC Button
1. Press and hold the MEM/ESC button. Memory icon
and the Memory Location show on the display.
TRI
MEM
WATCH
ESC
2. Press the Channel Up or Channel Down button
to select the memory location (0 through 9).
TRI
MEM
SCAN
H-M-L
WATCH
ESC
Channel Button
3. Press the MEM/ESC button to enter a
new memory location or edit an already
MEM/ESC Button
programmed memory location.
TRI
MEM
4. Press the Channel Up or Channel Down button
WATCH
ESC
to select the memory location.
TRI
MEM
SCAN
H-M-L
WATCH
ESC
5. Press the MEM/ESC button. The channel
Channel Button
numbers will flash on the display.
6. Press the Channel Up or Channel Down button
Vox
to select a channel (1 through 22).
I MED LO WX
7. Press the MEM/ESC button. The CTCSS icon
and privacy code numbers will flash on the
TW DCS Scan
Memory Channel
display.
CTCSS Mem
8. Choose one of the following:
a. Press the Channel Up or Channel Down
MEM TRI
SCAN
H-M-L
WATCH
RP Power Saver ESC
Channel Button
b. Press the MEM/ESC button to switch from
English
14
SCAN
H-M-L
If a location has been programmed before,
its associated channel/privacy code will be
shown on the display.
SCAN
H-M-L
button to select a CTCSS privacy code (01
through 38) for the channel.
CTCSS to DCS. The DCS icon and privacy code
numbers will flash on the display. The Channel
Up or Channel Down button can then be used
to select a DCS privacy code (01 through 83)
for the channel.
Introduction
•
If "oF" flashes in place of the privacy code numbers,
a privacy code is already set in the opposite (CTCSS
or DCS) system. Press the Channel Up or Channel Down
button to cancel the opposite code and select a privacy
code from the active system for the selected channel.
9. Choose one of the following:
a. Press the MEM/ESC button to enter the channel/privacy code
in the selected memory location. Radio then proceeds to next
memory location, which will blink.
b. Press and hold the MEM/ESC button to save the current state of
the Set Memory Function and return to Standby mode.
MEM/ESC Button
R
Vox
X
MEM
ESC
HI MED LO WX
TW DCS Scan
Memory Channel
CTCSS Mem
TRI
MEM
SCAN
H-M-L
WATCH
ESC
Channel Button
BURP Power Saver
Operation Customer Assistance Warranty
To recall a stored memory channel location:
1. Press the MEM/ESC button until the Memory
icon and the memory location number flash on
the display.
TRI
2. Press the Channel Up or Channel Down button SCAN
WATCH
to select a memory location (0 through 9).
If a location has been programmed before,
its associated channel/privacy code will be
shown on the display.
3. Press and hold the MEM/ESC button to return
to Standby mode on the selected memory
location.
A memory location can be reprogrammed
at any time it is displayed. Press the
MEM/ESC button to begin.
Nothing comes close to a Cobra
15
®