Roger Beep Confirmation Tone - Cobra CXT1035 FLT CAMO Owner's Manual

Mode Functions
TRI
MEM
SCAN
WATCH
ESC
Operation

Roger Beep Confirmation Tone

Your listener will hear an audible tone when you release the Talk button.
This alerts the other party that you are finished talking and it is OK for
them to speak.
To turn roger beep on or off:
Mode/Power
1. Press the Mode/Power button until the
Roger Beep icon flashes. The current
on or off setting is displayed.
2. Press the Channel Up or Channel Down button
Roger Beep On
to select roger beep on or off.
3. Choose one of the following:
a. Press the Mode/Power button to enter the
TRI
MEM
SCAN
H-M-L b. Press Talk or Call/Lock button to enter the
WATCH
ESC
Channel Button
new setting and return to Standby mode.
c. Do not press any buttons for 15 seconds to enter
the new setting and return to Standby mode.
12
new setting and proceed to other functions.
TRI
MEM
SCAN
WATCH
ESC
Introduction Operation
Key Tone On/Off
•
When Key Tone is On, an audible tone will sound each time a button
is pressed.
Mode/Power
TRI
MEM
SCAN
H-M-L
WATCH
ESC
Channel Button
Set High/Medium/Low (H-M-L) Power Button
Your radio can transmit selectively at 0.5, 1, or 2 watts of power Use
the low power setting for short-range communications and use the high
power setting for long-range communications.
H-M-L Button
TRI
MEM
SCAN H-M-L
WATCH
ESC
R
Hi/Med/Lo Icon
Vox
X
HI MED LO WX
TW DCS Scan
Talk Button
CTCSS Mem
BURP Power Saver
Customer Assistance Warranty
To turn key tone on or off:
1. Current key tone status On/Off will flash.
2. Press the Channel Up or Channel Down button
to select key tone on or off.
3. Choose one of the following:
a. Press the Mode/Power button to enter the
new setting and proceed to other functions.
b. Press Talk or Call/Lock button to enter the
new setting and return to Standby mode.
c. Do not press any buttons for 15 seconds to enter
the new setting and return to Standby mode.
To toggle between H-M-L Power Modes:
1. Press the H-M-L button to select between High,
Medium and Low power settings. The HI, MED
or LO icons will show on the display for the
selected level.
2. When the desired power is selected, press the
Talk button to enter the new setting and return to
Standby mode.
Channel 8 through 14 only operates on
TRI
MEM
SCAN H-M-L
WATCH
ESC
Low power setting.
Nothing Comes Close to a Cobra
•
•
13
®