Operation; Using Your Radio; Quick Start; Battery Low - Cobra CXT1035 FLT CAMO Owner's Manual

Using Your Radio

Operation

For charging microTALK radio(s) in desktop charger:
1. Insert radio(s) into desktop charger as shown.
2. Insert the micro-USB cable into jack on back
of charger. Note: charger should be installed near
the equipment and easily accessible.
3. Plug the charging cable into a power source.
For pluggable equipment, the socket-outlet shall
be installed near the equipment and shall be easily
accessible.
If charging light is not on, check position of radio. Radio should
be upright. The charge indicator light will stay on until the charging
is complete.

Quick Start

1. Press and hold the Mode/Power button
to turn on your radio.
2. Press the Channel Up or Channel Down
button to select a channel.
TRI
MEM
SCAN
WATCH
ESC
3. Press and hold the Talk button while
speaking into the microphone.
4. When finished talking, release the Talk
button and listen for a response.
Turning on Your microTALK
Press and hold the Mode/Power button until you hear
Mode/Power
a series of audible tones indicating the radio is on.
Your microTALK
ready to receive transmissions. The radio is always
in Standby mode except when the Talk, Call or
Mode/Power buttons are pressed.
2
Both radios must be tuned to the same
channel/privacy code to communicate.
Radio
®
radio is now in Standby mode,
®
Introduction

Battery Low

Battery Low
R
Vox
X
HI MED LO WX
TW DCS Scan
CTCSS Mem

Auto Battery Save

BURP Power Saver Battery Save Mode
Communicating with Another Person
Talk Button
Two Inches (5 cm)
from Mouth
To Select a Channel
•
TRI
MEM
SCAN H-M-L
WATCH
ESC
Channel Button
R
Vox
X
Channel Number
HI MED LO WX
TW DCS Scan
CTCSS Mem
BURP Power Saver
Operation Customer Assistance Warranty
When battery power is low, the final bar in the Battery
Low icon will blink and an audible tone will sound twice
before the radio shuts off. Your batteries should be
replaced or recharged, if using rechargeable batteries.
The radio's LCD display will show a blinking
charging staus indicator while charging.
If there are no transmissions within 10 seconds,
the radio will automatically switch to Battery Save
mode and the Power Saver icon will flash in the
display. This will not affect the radio's ability to
receive incoming transmissions.
1. Press and hold the Talk button.
2. With the microphone about two inches (5 cm) from
your mouth, speak in a normal voice.
3. Release the Talk button when you are
finished talking and listen for a response.
You cannot receive incoming calls while
pressing the Talk button.
Both radios must be tuned to the same
channel/privacy code to communicate.
With the radio on, select any of the 22 channels by
pressing the Channel Up or Channel Down button.
Both radios must be tuned to the
same channel to communicate.
Channels 1 through 7 are shared with FRS/ GMRS.
Channels 8 through 14 are FRS only. Channels 15
through 22 are GMRS only.
See page 20 for FRS/GMRS frequency
allocations and compatibility charts.
Nothing Comes Close to a Cobra
•
•
•
•
3
®