Dimming Modes; White Balance; Backlight; Product Temperature - Chauvet COLORdash Par-Hex 12 User Manual

Dimming Modes

White Balance

Backlight

Product
Temperature
Software
Information

Fixture Hours

LED Test

COLORdash™ Par-Hex 12 User Manual Rev. 1
This setting provides three different options to simulate the dimming curve of an incandescent
lighting product.
1. Go to the Dim Mode main level.
2. Select a dimmer curve (OFF, DIM1, DIM2, or DIM3).
OFF: The output is proportional (linear) to the dimmer.
DIM 1–3: The output follows the dimmer based on the corresponding dimmer curve,
DIM 1 being the fastest and DIM 3 the slowest.
This setting allows you to select the white color shown by the COLORdash™ Par-Hex 12 by
adjusting the red, green, and blue maximum values.
1. Go to the White Balance main level.
2. Select a color R, G, or B.
3. Go to the Value programming level.
4. Select a color value (125–255).
5. Repeat for the other colors.
When adjusting the white balance, you will only be able to define the values of red,
green, and blue.
This setting allows you to set the amount of time the backlight on the COLORdash™ Par-Hex
12's display stays on after the last button is pressed on the control panel.
1. Go to the BackLite main level.
2. Select On (remains on), 10S (10 seconds), 20S (20 seconds), or 30S (seconds).
This option shows the temperature (°C) of the COLORdash™ Par-Hex 12.
·
Go to the Temp main level.
This option shows what version of software the COLORdash™ Par-Hex 12 is running.
1. Go to the Info main level.
2. Select Version and the version number will show on the display.
This option shows the total amount of hours the COLORdash™ Par-Hex 12 has been turned
on.
1. Go to the Info main level.
2. Select FixHours and the total number of hours will show on the display.
This option runs a check of the LEDs on the COLORdash™ Par-Hex 12 by turning on all the
LEDs in sequence.
1. Go to the Info main level.
2. Go to the Auto programming level.
3. Go to the Test programming level.
Operation
-15-