Wiring; Power And Outputs; Power Terminal (Batt +12V); Ground Terminal (Gnd) - Jensen XA2100 Quick Manual

®

Wiring

Power and Outputs

Power Terminal (BATT +12V)

Connect directly to the vehicle battery+
terminal with 8 gauge wire (minimum).
Not Supplied
30 amp Fuse
or Circuit Breaker
Battery
Install as close
Terminal
to the battery
Adapter
as possible

Ground Terminal (GND)

Connect to a good chassis ground. The ground
connection should be to clean, unpainted metal
to provide a good electrical connection.
+ 12V
Sheet Metal
Screw
Ring
(supplied)
Connector
Drill 1/8" hole
in chassis
sheet metal
4
+ 12V RMT GND
FUSE
POWER
+ 12V RMT GND
Spade
Connector
8 Gauge
Wire
To Battery+
Terminal
RMT GND
Spade
Connector
8 Gauge
Wire
L + L – R – R +
SPEAKER

Remote Terminal (RMT +12V)

Connect the radio power antenna lead from
the receiver to the amplifier REMOTE terminal.
This turns the amplifier on whenever the re-
ceiver is turned on. If a power antenna lead is
not available, connect this wire to the radio or
accessory fuse.
+ 12V
Butt
Connector
(not supplied)
To Receiver
Power
Antenna Lead

Fuses

FUSE
Use only one 15 amp
blade-type fuse.
XA2100
RMT GND
Spade
Connector
8 Gauge
Wire