Inputs And Controls; Input Wiring; Pass Output; Power Light - Jensen XA2100 Quick Manual

XA2100

Inputs and Controls

HIGH INPUT
POWER

Input Wiring

Inputs may be high level (from the receiver's
speaker) or low level (from special low level
outputs). Low level input is preferred for best
performance.
Important
Use only the low level or high level input, do
not use both at one time.
Low Level Input
Use a pair of shielded stereo audio cables with
RCA type jacks. Most trunk-mount amplifier
installations require 20-foot RCA cables. Most
under-seat and pickup truck installations use
12-foot cables.
Connect RCA cables from your receiver to the
RCA input jacks on the amplifier.
High Level Input
Connect left and right speaker wires coming
from radio to high level input plug as shown.
L R
+ – – +
Splice (as
necessary)
HIGH INPUT
POWER
Hi level
input plug
on amp
LOW INPUT
L R
White-Left (+)
White/Black-Left (–)
Gray-Right (+)
Gray/Black-Right (–)
Black (ground)
Radio
L R
or
LOW INPUT
L R

PASS OUTPUT

L R
Pass Output
PASS OUTPUT
Use pass through (PASS
OUTPUT) connectors for
adding other amplifiers.
L R

Power Light

The power light comes on when 12
volt power is available at both the
POWER
battery +12 volt and RMT wires.

Protect Light

The red protect light comes on
when the amplifier shuts down from
PROTECT
overheating or a short circuit
(speaker failure).
®
PROTECT
5