Wiring; Power And Outputs; Power Terminal (Batt +12V); Ground Terminal (Gnd) - Jensen LXA600 How To Install And Operate

®

Wiring

Power and Outputs

Power Terminal (BATT +12V)

Connect directly to the vehicle battery+
terminal with 8 gauge wire (minimum).
Not Supplied
50 amp Fuse
or Circuit Breaker
Battery
Install as close
Terminal
to the battery
Adapter
as possible

Ground Terminal (GND)

Connect to a good chassis ground. The ground
connection should be to clean, unpainted metal
to provide a good electrical connection.
Ring
Connector
Drill 1/8" hole
in chassis
sheet metal
4
6022Eamp.p65
FUSE
+ 12V RMT GND
POWER
+ 12V RMT GND
Spade
Connector
8 Gauge
Wire
To Battery+
Terminal
+ 12V RMT GND
Spade
Sheet Metal Connector
Screw
(supplied)
8 Gauge
Wire
4
A-CH B-CH C-CH D-CH
+ – – + + – –
SPEAKER

Remote Terminal (RMT +12V)

Connect the radio power antenna lead from
the receiver to the amplifier remote (RMT)
terminal. This turns the amplifier on whenever
the receiver is turned on. If a power antenna
lead is not available, connect this wire to the
radio or accessory fuse.
Butt
Connector
(not supplied)
To Receiver
Power
Antenna Lead

Fuses

FUSE
Use only two 25 amp
blade-type fuses.
02/08/01, 4:27 PM
LXA600
+
+ 12V RMT GND
Spade
Connector
18 Gauge
Wire