Samsung Digimax S500 Service Manual page 17

< Note > DirectX is required about 55MB hard disk space. It will take about 22MB hard disk space.
It will change settings of applications and registries. You can't remove it as the OS doesn't have
uninstall program.
Q3. My computer can't recognize the camera.
A3. (1) Install the supplied USB Driver.
(2) Check the USB cable connection between the compter and camera.
(3) The connected camera must be turned on. If the battery capacity is low, change it with fully charged one
or use the AC adapter.
4) USB menu of the camera setting must be set as Computer.
You can change the setting in the Setup menu of the camera by using the 5 function button.
(5) If connect the camera to the computer without installing the USB Driver, the compter may not recognize
the camera. In this case, remove the cable and install the USB drive first.
6) If other USB cables are connected to the compter, remove them.
Sometimes the devices crash each other. Remove them and reboot the computer. And then check
whether the computer can recognize the camera.
(7) If the steps 1-6 are correct, remove the USB driver and install again.
Q4. How can I check whether the USB Driver was installed correctly?
A4. Install the USB Driver and connect the camera and the computer with the supplied USB cable. And then turn
them on. You can find the removeable disk.
(1) "The device is working properly" message will display on the system information window.
(2) The camera driver file has to be installed under the following folders.
< Windows 98/98SE >
S500.inf : Windows/inf
DSCPDR.pdr : Windows/system/iosubsys
DSCSYS.sys : Windows/system32/drivers
< Windows ME / 2000 / XP >
usbstor.sys : Windows/system32/drivers
usbstor.inf : Windows/inf
17
Ⅱ. INSTALLATION & FAQ