Table of Contents
Advertisement
Wiring Options
Your HD28 Series camera is supplied with a coaxial termination board mounted
to the bottom of the enclosure. All connections are made here (see
Figure 3
Connecting the Wiring
1.
Pull the cables through either the back or the side conduit.
2.
To minimize moisture leaking into the housing, position the enclosure with
the conduit pointing down. Apply an appropriate sealant around the conduit
connection.
Adjusting the Camera
To adjust the HD28 camera:
1.
Apply 12 VDC or 24 VAC to the camera and monitor the video signal.
2.
Loosen the screws that lock the gimbal assembly in place (see
3.
Adjust the camera carrier to the desired view (see
4.
Tighten the screws to lock the gimbal assembly in place.
Note
Orient the camera as shown in
picture orientation.
Rev 1.01
Wiring Options
Coax Termination Board
Not used
4
Video
Audio
Power
Case/
Ground
Figure
Figure 4
to maintain the correct
Figure
3).
Figure
4).
4).
Document 900.0275
10/05
Advertisement
Table of Contents
