Installation; Mounting The Camera; Preparing The Mounting Surface - Honeywell HD28C4HR6 Installation Manual

Premium vandal dome camera ntsc / pal
Table of Contents

Advertisement

Installation

Your HD28 camera is weather-sealed for indoor or outdoor locations. The wiring
can be completely concealed for maximum vandal and tamper resistance.

Mounting the Camera

The HD28 camera is designed to be surface mounted on a wall or ceiling.

Preparing the Mounting Surface

1.
Affix the mounting template to the mounting surface (see
2.
Pre-drill four holes as indicated on the template, using the recommended
hole size for the screws being used.
3.
Drill out the conduit hole, if required (see
4.
Connect the wiring (see
5.
Mount the camera base to the wall or ceiling using mounting screws (not
supplied) capable of holding at least twice the weight of the camera.
Note
Alternate fasteners (preferably stainless steel) can be used, provided
they are not larger than the screw holes on the mounting template.
Figure 1
Rev 1.01
Connecting the
Mounting Template Guide
2
Installing the Conduit
Wiring).
Mounting screws
appropriate to your
installation (not
supplied)
Figure
1).
Plug).
Document 900.0275
10/05

Advertisement

Table of Contents
loading

Table of Contents