Lenovo ThinkCentre 6136 Hardware Maintenance Manual page 95

6. Rotate the adapter card retainer to the open position and remove the adapter
card being replaced by pulling it out of the adapter card slot.
Figure 11. Removing the adapter card
7. Remove the new adapter card from its static-protective package.
8. Install the new adapter card into the adapter card slot. Make sure that the
adapter card is firmly fixed in the slot and does not move easily.
9. Close the adapter card retainer.
10. Slide the system board to the rear of the chassis and then pivot the system
board until it is locked by the mounting stud on each side of the cover.
11. Reconnect all cables that were disconnected from the system board.
12. Go to "Completing the FRU replacement" on page 106.
Chapter 8. Replacing FRUs
89