Table of Contents
Advertisement
CHAPTER
22
Operating a controller and attached cradles
When an AutoRAE 2 Controller is attached to one or more AutoRAE 2 Cradles, the buttons on
the AutoRAE 2 Cradles are only used to initiate a bump test or calibration. The two-character
LED displays on each Cradle show the ID number for the respective Cradle. All operations and
settings are controlled by the AutoRAE 2 Controller.
Turning the AutoRAE 2 controller on
Toggle the switch on the side of theAutoRAE 2 Controller. The LCD display turns on and the
LED on the on/off switch glows red. The system performs a self-test, covering the AutoRAE 2's
internal pump and valves, Terminal Adapter, gas pressure in connected cylinders, and other
vital components and parameters. As each cradle is powered up, its Bump and Cal LEDs turn
on momentarily and the two-character LED display lights up showing the Cradle ID number in
the system.
Turning the AutoRAE 2 controller off
Toggle the switch on the side of the AutoRAE 2 Controller. The display and power LED go dark,
as do all the LEDs on attached cradles.
AutoRAE 2
OPERATION
76
User Manual
Advertisement
Table of Contents
