Table of Contents
Advertisement
AR-PB2A
[3] SETUP
1. Parts list
Before installing the printer kit, check that all the following items are prepared.
Be careful that the necessary parts depend on the environment of the copier (model and unit installation).
Accessories
SCSI cable
Wire saddle
Band
Printer box installing screw
Printer control PWB
Printer driver
Installation manual
Operation Manual
Label
Option
Expansion board
SIMM memory
Network card
Separate purchase
Printer (parallel) cable
(User purchase)
2. Preliminary work
If the version of the three kinds of flash memory installed to the copier
is older than the following, upgrade is required.
Check version number, and perform the upgrade if necessary. (For
the procedure, refer to the Technical Report.)
3. Hardware setup
A. Common work
(1) Printer unit installation
1) Turn "OFF" the main switch located on the left-hand side on the
main copier unit.
Next, unplug the power plug of the main copier unit from the
outlet.
Main switch
2) Removing the rear cover of the main copier unit.
If equipped with the RADF/ADF/SPF, loosen the securing screws
which the hold the RADF/ADF/SPF connector and remove the
connector from the main copier unit.
Part name
Printer Driver (including PPD File)
Screen Font
Resident-FontData Install Utility
Printer Administration Utility ver.2.x
NWsetup
Printer Status Monitor ver.2.0
Integrated Installer
Makedisk Utility
16MB
32MB
"OFF"
Model
Q'ty
1
1
1
5
1
With frame
1
1
1
1
1
1
1
1
1
1
1
Only for Sweden and Norway
AR-EB1
1
The expansion board is necessary to
install the printer kit to the AR-S280.
ED0 type/Without parity/70ns or above
The copier ICU PWB requires the total
memory of 16MB(20MB) or more.
The printer control PWB has two
expansion slots to which 16MB or 32MB
memory can be additionally installed.
(16MB onboard)
AR-NC3D
1
10Base-T / 100Base-TX
Necessary when the copier is used as a
stand-alone machine.
Connector
If the rear cabinet is a box type, remove the connector cover in
advance.
Remove the five securing screws which hold the rear cover of
main copier unit, then remove the rear cover.
Next, loosen the upper central one of four securing screws which
hold the rear lower cover, then remove the rest three screws, and
then remove the rear lower cover.
Rear cover
Securing
screw
Loosen
Rear
lower cover
Securing screws
3 – 1
Note
Screw
If the rear cabinet is a box type:
Rear
cover
Securing
screw
Connector
cover
Loosen
Rear
lower cover
Securing screws
Advertisement
Table of Contents
