Figure 3.11: OSCAR Interface Name Modify Dialog Box
2.
Type a name in the New Name box. Names of target devices may contain all
printable characters.
3.
Click OK to assign the new name.
4.
Repeat steps 1-3 for each target device in the system.
5.
Click OK in the Names dialog box to save your changes.
-or-
Click X or press
NOTE: Changes made in the Names Modify dialog box are not saved to the switch until you click OK in the
Names dialog box.
NOTE: If an IQ module has not been assigned a name, the EID is used as the default name.
Commands Dialog Box Functions
From the OSCAR interface Commands dialog box, you can manage your AutoView 3008/3016
switching system and user connections, enable the Scan mode and update your firmware.
Table 3.6: Commands to Manage Routine Tasks for Your Target Devices
Features
Scan Enable
User Status
AVRIQ Status
to exit the dialog box without saving changes.
Escape
Purpose
Begin scanning your target devices. Set up a target device list for scanning in the Setup
dialog box. You must have at least two target devices selected in the Setup - Scan List
menu to enable target scanning.
View and disconnect users.
Displays the currently available firmware for each type of AVRIQ module.
Chapter 3: Local Port Operation
25