TK-2302/2302
8. Attaching the Antenna Receptacle to the Chassis
Screw the antenna receptacle to the chassis in the order
shown in the drawing so that the antenna receptacle
comes to the center of the case hole.
Tighten this screw first.
9. The Nuts of the Volume Knob and Channel Knob
Note that the shapes, colors and heights of nuts of the
volume knob and channel knob are different from one
another. (The nut of volume knob is silver, and the nut of
channel knob is gold)
Use the following jig when removing the nuts of the vol-
ume knob and channel knob.
• Jig (Part No.: W05-1012-00)
Volume knob
(Long)
8
V
/2306
(
)
DISASSEMBLY FOR REPAIR
Tighten this screw second
Channel knob
(Short)
10. Screw sequence for mounting the TX-
RX unit to the chassis
Attach the TX-RX unit to the chassis using the screws in
the order shown in the drawing below.
Note: From screw r onward no sequence is need.
TX-RX UNIT
Component side view