Kenwood TK-2302 Service Manual page 7

5. Assembling the Battery Release Lever
1. Place the lever w onto the stopper q.
2. Place the thick spring e onto the lever.
3. Hook the right and left ends of the thin spring r onto the
tabs of the stopper, then place the thin spring onto the
lever t.
4. Slide the shaft through the hole of the stopper and lever
y.
6. Attaching the Positive Terminal to the Chassis
Always attach the positive terminal to the chassis, using
the following procedures, before mounting the TX-RX unit
onto the chassis.
1. Remove the holder assembly w from the packing q of
the positive terminal.
2. Mount the packing of the positive terminal into the chas-
sis hole e.
3. Mount the holder assembly into the packing of the posi-
tive terminal r.
DISASSEMBLY FOR REPAIR
TK-2302/2302
7. Mounting the Chassis to the Case Assembly
1. Confirm that the waterproof packing attached to the
circumference of the chassis is securely inserted in the
groove of the chassis q.
2. Attach the speaker with waterproof packing to the
speaker recess of the case assembly w. Make sure the
speaker clasp is securely inserted.
3. Tighten the speaker clasp into the case assembly with
the screw.
4. Insert the upper part of the chassis into the case assem-
bly e.
Caution: Take care that the speaker lead wire is not
caught by the microphone element.
5. Press the chassis r and the case assembly together to
attach them.
Caution: If the packing of the SP/MIC does not come
to the correct position after attaching the chassis to the
case assembly, reposition the packing with your fi ngers.
Confirm that the
waterproof packing is
securely inserted in the
groove of the chassis.
V /2306
( )
7