Daewoo DTD-29M1 MEO Service Manual page 45

PIN NAME
37 DIG.VDD A Vdd terminal for of digital block.
Supply HVcc voltage through 270 ohms of
resistance.
The voltage of this terminal is clipped to
approximately 3.3V by the internal regulator.
38 SYNC IN An input terminal for Sync signal.
The input sync tip is clamped by
charging/discharging the coupling capacitors
so as to align the Sync slice level.
Input is through a low impedance buffer,
(input level 1Vp-p/140IRE)
39 Y IN An input terminal for Y signal.
The pedestal level is clamped by means of
charging/discharging the coupling capacitor,
therefore input through low impedance buffer.
(1Vp-p/140IRE input level)
40 DC RESTOR A terminal to be connected wiht a capacitor to
detect the average picture level for DC
restoration.
The ratio of the DC restoration is set by bus.
Leave this terminal open if the DC restoration
is not required.
FUNCTION
- 10 -
IC DESCRIPTION
INTERFACE
31
37
30 30
30 750
38
1k
39
1k
1k
1k
50k
40
50k
APPENDIX
H VCC
2.6V
31
33
42
19
42
19