Daewoo DTD-29M1 MEO Service Manual page 40

APPENDIX
IC DESCRIPTION
PIN NAME
8 RF AGC
9 1'st SIF IN
10 IF AGC
11 APC FILTER
12 X'TAL
(4.43MHZ)
FUNCTION
An output terminal for RF AGC.
A pull up resister is required because of its
open collector output. A de-coupling capacitor
is also connected to reduce noise.
An input terminal for 1'st SIF signal.
A terminal should be connceted to an IF AGC
filter. Connect 2.2uF capacitor to Vcc.
A terminal should be connected with an APC
filter for chroma demodulation.
This terminal voltage controls the frequency
of VCXO.
A terminal should be connected with a
4.433619MHz X'tal oscillator. The oscillated
signal leads to the chroma demodulation, H
out frequency tuning, AFT, etc.
- 5 -
INTERFACE