Needle Threader - Husqvarna Viking Huskystar EM10 User Manual

Needle Threader

After placing the thread behind the
fi nal guide just above the needle,
you can thread the needle using
the built-in needle threader.
1. With the presser foot raised
and the needle in the
up position, bring thread
through upper thread path as
described on the preceding
page.
2. Lower the presser foot. Lower
and move the threader lever
forward until it stops. A small
hook comes through the eye
of the needle.
3. Pull the thread across the
threader from left to right.
4. Gently move the threader lever
up and back. The hook will pull
the thread through the eye.
5. Grasp the loop of thread
behind the eye of the and pull
out a length of thread.
GET READY TO EMBROIDER
If the needle
threader does not
thread the needle,
check to assure that
it is aligned with the
eye of the needle
and that the needle
is inserted as high
as it will go in the
slot.
Take care that you
do not press the
Start/Stop button
during threading.
15