Husqvarna Viking Huskystar EM10 User Manual page 12

User's Guide
A
B
1
2
C
3
10 10
C
Thread stand
When using small spools of thread, use the thread
stand to help the thread come off the spool evenly.
To attach the thread stand, follow the steps below.
1. Hold the thread stand so that the hooks (A) and
(B) on the thread stand are facing to the right
(1).
2. Attach the two hooks into the back of the spool
pin base (2). Insert the hook A into the spool
pin base and then push hook B over the spool
pin.
3. Place a spool of thread on the spool pin leaving
a small space between the spool and the spool
pin base (C).
4. Place the spool cap on the spool pin. Make
sure there is a small space between the thread
spool and the spool cap (C).
5. Bring the thread from spool up through the
thread stand curly Q from the back to the front
and thread the machine as usual.