Table of Contents
Advertisement
can be adjusted by two tilting adjustment screws as shown in Figure 14 (M6 x 12mm Allen set
screws, not supplied).
M6 set screws
Figure 14. Secondary dovetail and set screws
A combination of a light OTA and a CW can be used to balance a heavier primary OTA.
2.4. Operate a MiniTower II on Batteries
To install batteries, open the battery compartment door. Pull the battery holder out from the
mount carefully making sure not to pull the wires loose. Insert 8 AA batteries (not included)
according to the diagram on the holder. Replace the battery holder back to the battery
compartment and replace the cover. (See Figure 15)
Figure 15. Battery compartment for MiniTower™ II
The mount will draw a significant amount of current when performing GOTO and slew
operations. The battery operation time varies depending on the battery quality and operation
conditions. It could last from couple of hours to tens of hours. Use only fresh batteries and do
not mix fresh and old batteries. Insufficient battery power may cause error messages.
11
iOptron Corp. | 6E Gill Street | Woburn, MA 01801 USA | (781) 569‐0200 | Toll Free (866) 399‐4587 | www.iOptron.com
Advertisement
Table of Contents
