Adjusting The Door - Lopi heritage bay Owner's Manual

M
AINTAINING
P 18
AGE
7 To check the door seal, place a dollar bill along the door perimeter then close and latch the door. If
the dollar bill is held in place securely, the door seal is adequate. However, it the dollar bill slides
out easily, you should adjust the door. See the directions below to tighten the door seal.
To tighten the door seal:
¥ Open the door (see page 10).
¥ Tighten each door latch pawl one turn.
¥ Close and latch the door. Open up the right side panel. Loosen the two attachment nuts
on each hinge assembly 1/2 turn. Adjust both adjustment nuts on each hinge assembly 1
turn to bring the hinge closer to the rear of the heater (Note: the dimple above the hinge
assembly can be used to gauge hinge location). Re-tighten the attachment nuts.
¥ Check the door seal again. If it is still not tight, repeat the above three steps.
Swing the left
panel back.
8 Start the pilot and turn on the main burner. The flames should be orange/yellow and not touch the
top of the firebox. If the pilot or main burners do not burn correctly, contact your dealer for service.
Monitor the blower operation.
9 Remove any debris or vegetation near the vent termination. Contact your dealer if any sooting or
deterioration is found near the vent termination.
Y H
OUR EATER
NOTE: Do not overtighten the pawl by screwing it in
too far. This will permanently damage the latch.
Door
Frame
(C )
ONTINUED
Rotate the pawl in one turn
Dimple (used for
gauging hinge position.
Hinge Attachment Nuts
(loosen 1/2 turn)
Door
Frame
Hinge Adjustment Nuts
(turn 1 turn - adjust the nut
closest the door frame first)