Installation Tip - Safety 1st Complete air 65 Instruction Manual

4358-5295 Complete Air 7/15/10
F-5 Install Forward-Facing
With Vehicle Belts
1.
2.
Do not use the LATCH system along with the
vehicle belt. Secure LATCH belts when using
the vehicle belts.
Check the vehicle belt before each use. Use only
if the belt is tightened properly and securely.
Failure to follow these warnings can result in
serious injury or death.
52
8:38 AM Page 55
Child Restraint Must be
Upright
Rotate recline stand out and
push upward to lock in
position.
Secure LATCH Belts
You MUST fasten the
LATCH belt connectors to
the side of plastic shells as
shown when using the
vehicle seat belts.
Note: Review the section D-4 to determine what kind of
vehicle belts you have. Review your vehicle's owner manual
for vehicle seat belt use.
3.
Place Child Restraint
in Vehicle
Forward-Facing
Place child restraint flush
against the back of the
vehicle seat forward-
facing in the back seat.

Installation Tip:

Loosely attach the
top anchorage
hook (tether)
before threading
the vehicle belt.
Consult vehicle's
owner manual for
specific location.
NOTE: If you are not using
the top anchorage strap
(tether), attach the hook to
the recline stand as shown.
Tighten tether to remove the
slack.
4.
Thread Vehicle Belt
Thread the vehicle lap or
lap/shoulder belt
combination through the
forward-facing belt slot and
out the other side. Buckle
vehicle belt.
53
Meijer.com
continued on next page.