Using The Locking Clip - Safety 1st Complete air 65 Instruction Manual

4358-5295 Complete Air 7/15/10
D-5 Using the Locking Clip
A locking clip will not fix all types of vehicle seat belt
problems. Review section D-4 and your vehicle's owner
manual for vehicle seat belt use with child restraints. The
locking clip is located on the back of the child restraint.
The following directions describe installing the child restraint
rear-facing. Same steps apply for forward-facing, except
install the restraint forward-facing and thread the vehicle belt
in the forward-facing belt path.
Do not use both the LATCH belt and vehicle
belt at the same time.
1.
2.
34
8:38 AM Page 37
Place Child Restraint in
Vehicle Rear-Facing
With child restraint in the
reclined position, make sure
level lines on the side of the
child restraint are level with
ground. Adjust child restraint
if needed.
NOTE: Store top anchorage
hook (tether) on recline
stand. See section E-1.
Thread Vehicle Belt
Thread the vehicle
lap/shoulder belt
combination through the
rear-facing belt slot.
3.
Pull Vehicle Belt Across
Child Restraint
Thread vehicle seat belt
under pad in front of
1
2 buckle strap to the
opposite side. Buckle
vehicle belt.
Do not place vehicle belt
over child's legs.
NOTE: The buckle MUST be in the 1st or 2nd buckle strap
slots when rear-facing. Any slot can be used for
forward-facing.
4.
Tighten Vehicle Belt
Push down firmly on the
child restraint and while
pulling on the vehicle
shoulder belt to tighten.
5.
Locate Locking Clip
Location
Grasp both vehicle belts
together just behind the
latch plate and unbuckle.
NOTE:
ends up just at the belt
path opening, grasp the
vehicle belts on the
opposite side of the child
restraint, as close to the
latch plate as possible.
35
Meijer.com
If the latch plate
continued on next page.