Safety 1st Complete air 65 Instruction Manual page 22

4358-5295 Complete Air 7/15/10
E-3 Install Rear-Facing with
LATCH
1.
Do not use the LATCH system along with the
vehicle lap or lap/shoulder belt.
Check LATCH belt before each use. Use only if the
belt can be tightened properly and securely.
Attach the top anchorage hook (tether) to recline
stand when used rear-facing.
Failure to follow these warnings can result in
serious injury or death.
2.
3.
40
8:38 AM Page 43
Fold the recline stand
under the child restraint
Store Top Anchorage
Hook (Tether)
Attach the top anchorage
hook (tether) to recline
stand as shown. Tighten
tether to remove the slack.
Place Child Restraint in
the Back Seat Rear-
Facing
Move the front seats forward
to give you room to install the
child restraint. With the child
restraint in the fully reclined
position, center the child
restraint in the chosen
seating position.
Note: Review your vehicle's owner manual for LATCH belt use.
4.
Check for Proper
Recline
Make sure level lines on
side of plastic shell are
level with ground. Adjust
child restraint if needed.
A
You may need to place a
large rolled towel(s) (A) or
foam pool noodle(s) under
the front of the child
restraint to allow the level
line on the side of the
plastic shell to be level with
the ground. Check often to
be sure padding is still in
place and the LATCH belt is
tight.
5.
Connect LATCH to
Vehicle LATCH Anchor
NOTE: The LATCH's red
release button MUST face
away from child restraint
and the arrows on
connectors MUST face up.
Fasten one LATCH belt
connector to the anchor in
the vehicle seat located in
the vehicle seat bight.
Repeat for other side of
child restraint.
41
Meijer.com
continued on next page.