Governor Adjustment - Robin EC05-2 Service Manual

8-2 GOVERNOR ADJUSTMENT
The governor linkage should be adjusted, after reassemble it according to the following procedures.
1) Connect governor rod and rod spring to carburetor throttle lever and governor lever, then install these t o governor
shaft.
NOTE: Never tighten adjusting plate set screw at this time, and do not fixed adjusting plate, governor lever and governor
shaft
2) Connect governor lever and control lever with governor spring, and install control lever o n crankcase.
8-2-1 IN CASE OF MODELS EC10, EC17 (See Figs. 8-2-1,8-2-2 and 8-2-3.)
As shown by arrow mark on Fig. 8-2-1 turn control lev-
er t o high speed side (clockwise) until stop fully, and
fasten the control lever by tightening wing bolt.
Loosen lock nut at the end of governor shaft and set
screw on adjusting plate.
As shown
by
the arrow on F i g . 8-2-2, move adjusting
plate
all
the way until it will not travel
any
more.
Tighten both lock nut at the end
of
governor shaft as
shown on Fig. 8-2-3 and set screw on adjusting plate.
Fig. 8-2-1
Fig, 8-2-2 Fig. 8-2-3
-34-