Wiring - Robin EC05-2 Service Manual

*
Mount the driving pulley as close to the engine as possible.
*
Span the driving belt horizontally, if possible.
*
When starting the engine, disconnect the load.
If a clutch is not available, a tension pulley or other means must be employed.
5-5-2 FLEXIBLE COUPLING
When a flexible coupling is used, the run out and mis-alignment between the driven shaft and the engine shaft must be made
as small as possible.
The tolerance on the run out and mis-alignment are specified by each coupling manufacturer.
"c3
JIS CB104 female terminal
JIS CA104 male terminal
4
LA104 or LA108 plate terminal
CONDENSER
ONTACTBREAKER
STOP BUTTON
LIGHTING SWITCH LAMP (6V
-
8V. 15W)
" " "
IGNITION COIL
SPARK PLUG
p "
r'
\ '
-
18-