Interface; B. Parallel Interface; Moving - Sharp AR-168S Service Manual

11. Interface

A. USB
Connector
4-pin ACON UBR23-4K2200
Type-B connector
Cable
Shielded twisted pair cable
(2 m (6 feet) Max.: high-speed transmission equivalent)
Pin configuration
The pin numbers and signal names are listed in the following table.
Pin No.
1
2
3
4
2
3

B. Parallel interface

This printer uses a bi-directional parallel interface. Use the supplied
interface cable.
Connector
36-pin ACON RBE42-36K1153 female connector or equivalent con-
nector
Cable
Shielded type bi-directional parallel interface For best results, use a
printer interface cable which is IEEE1284 compliant.
Pin configuration
The pin numbers and signal names are listed in the following table.
18
36
Signal name
+5V
-DATA
+DATA
GND
1
4
1
19
AR-168S/168D UNPACKING AND INSTALLATION 5 - 12
Pin No. Signal name
1 STB
2 DATA1
3 DATA2
4 DATA3
5 DATA4
6 DATA5
7 DATA6
8 DATA7
9 DATA8
10 ACKNLG
11 BUSY
12 PE (Paper End)
13 SLTC
14 AUTO LF
15 (NC)
16 GND (0 V)
17 FG
18 +5 V

12. Moving

Moving instructions
When moving the unit, follow the procedure below.
Note: When moving this unit, be sure to remove the TD cartridge in
advance.
1) Turn the power switch off and remove the power cord from the out-
let.
2) Open the side cover and front cover, in that order. Remove the TD
cartridge and close the front cover and side cover, in that order.
To open and close the side cover and front cover, and to remove
the TD cartridge.
3) Raise the handle of the paper tray and pull the paper tray out until it
stops.
4) Push the center of the pressure plate down until it locks in place
and lock the plate using the pressure plate lock which has been
stored in the front of the paper tray.
5) Push the paper tray back into the unit.
6) Lock the scan head locking switch.
Note: When shipping the unit, the scan head locking switch must be
locked to prevent shipping damage.
7) Close the multi-bypass tray and the paper output tray extension,
and attach the packing materials and tape which were removed
during installation of the unit.
8) Pack the unit into the carton.
Pin No. Signal name
19 GND (STB RET)
20 GND (DATA1 RET)
21 GND (DATA2 RET)
22 GND (DATA3 RET)
23 GND (DATA4 RET)
24 GND (DATA5 RET)
25 GND (DATA6 RET)
26 GND (DATA7 RET)
27 GND (DATA8 RET)
28 GND
(ACKNLG RET)
29 GND (BUSY RET)
30 GND (PE RET)
31 INPRM
32 FAULT
33 (NC)
34 (NC)
35 +5 V
36 SLTC IN