Sharp AR-168S Service Manual page 116

Main Sub
Contents
code code
66 18 DTMF signal send (Soft SW
set value) (Executable only
when the FAX is installed.)
21 FAX information print
(Executable only when the
FAX is installed.)
24 FAST SRAM clear
(Executable only when the
FAX is installed.)
30 TEL/LIU status change
check (Executable only
when the FAX is installed.)
[Function]
Use to set the DTMF signal send (Soft SW set value).
[Operation]
1) Initial display
INPUT DIAL #
[CLEAR] key: FAX control is terminated.
2) [10KEY] input
The content selected with signal send level
selection is set inside.
[Function]
Use to print the FAX information.
[Operation]
1) Initial display
SELECT REPORT (1-3)
PRESS ,
2) [ / ] or after 2sec
Every time when [ ] key is pressed, the second line is changed in the sequence of 1
1.
When [ ] key is pressed, the sequence is reversed.
SELECT REPORT (1-3)
1:USER SW. LIST
[CLEAR] key: FAX control is terminated.
3) [ENTER] key
• When print is allowed
PRINT STORED
After completion of printing,
FAX control is terminated.
[Function]
Use to clear the FAST SRAM.
[Operation]
1) Initial display
CLEAR FAST SRAM
[Function]
Use to check the TEL/LIU status change.
[Operation]
1) Initial display
HS2 :xxx HS1 :xxx
RHS :xxx EXHS:xxx
The display is switched every 2sec.
CHECKING
PRESS CLEAR TO STOP
[CLEAR] key: FAX control is terminated.
AR-168S/168D TEST COMMAND, TROUBLE CODES 10 - 36
Details of function/operation
3) Communication is started after setting the
signal send level.
SENDING SIGNAL SSW
PRESS CLEAR TO STOP
[CLEAR] key: Returns to "1) Initial display".
SELECT REPORT (1-3)
2:SOFT SW. LIST
• When print is inhibited
CAN NOT PRINT
After 2sec, FAX control is
terminated.
2) After completion of clearing
CLEARED
After 2sec, FAX control is terminated.
2 3
SELECT REPORT (1-3)
3:PROTOCOL