Cisco 7200 VXR Quick Start Manual page 40

Replace the SFP–NPE-G2
Figure 22 Inserting an SFP Module into the NPE-G2 Gigabit Ethernet Port 0/1
L I N K
A C T V
E N
G IG A B IT
E T H E R
N E T 0 /
L IN K
A C T V
R J 4 5 E N
2
1 SFP port 0/1
Use the following procedure to install an SFP module in the NPE-G2:
Step 1 Attach an ESD-preventive wrist strap between you and an unpainted chassis surface.
Step 2 Locate the label on the SFP module and turn the SFP module so the label is on top and the alignment groove is down.
Note The SFP module is keyed so that it cannot be inserted incorrectly.
Step 3 Insert the SFP module into SFP port 0/1, 0/2, or 0/3. The SFP module snaps into place when you have completely and
properly inserted it.
Step 4 Repeat Step 2 if you are inserting a second or third SFP module.
Installing a USB Flash Memory Module or eToken—NPE-G2
Figure 23 Connecting a USB Flash Memory Module to a Router USB Port
A U X
40
1
1
G IG A B IT
E T H E R
N E T 0 /
2
L IN K
A C T V
R J 4 5 E N
F E
L IN K
F E 0 /2
U S B
F O R M A
N A G E M
E N T
U S E O N
L Y
2 SFP module
U
S
B