Cisco 7200 VXR Quick Start Manual page 12

Figure 6 Installing the Rear Cable-Management Brackets with an NPE-G1 or NPE-G2 Installed—Router Front-Mounted
G I G A B I T E T H E R N E T 0 / 1
L I N K
E N
R J 4 5 R X
NPE-G1 and NPE-G2 Rear Cable-Management Brackets on a Front-Mounted Router
If you have an NPE-G1 or NPE-G2 installed, install cable-management brackets on the rear of the router as well as on the front
of the router.
Step 1 If the back of the router protrudes from the rack, place the cable-management brackets against the router as shown in
Figure 6.
Step 2 Insert two screws into each bracket, and tighten them to the router.
Go to the "Two-Post or Four-Post Rack Installation" section on page 16.
12
G I G A B I T E T H E R N E T 0 / 1
G I G A B I T E T H E R N E T 0 / 1
NETWORK PROCESSING ENGINE - G1
L I N K
L I N K
C P U
R E S E T
E N
E N
G B I C T X R J 4 5
R X G B I C T X
R J 4 5 R X G B I C T X
S L O T
A C T I V E
POWER
C O M PA C T F L A S H
OK CONSOLE AUX