LG CF181D Owner's Manual page 33

Replacing the Lamp
1
Turn off the projector and unplug the power cable.
Carefully place on a cushioned surface.
(Allow the lamp to cool for 1 hour before
removing the used lamp from the projector.)
After lifting the lamp cover off, remove the two
3 retaining screws on the lamp case with a screw-
driver.
Screws
5
Pull out the handle slowly and remove the lamp
case.
7
Tighten the screws you removed in step 3.
(Make sure they are fixed firmly.)
Using another manufacturers lamp may cause damage to the projector or lamp.
Make sure the lamp cover is securely fastened. If the lamp cover is not installed correctly the unit will not power on.
If this fault persists contact an LG Authorized Service Center.
2
Unscrew the screw from the lamp cover using a
screwdriver.
Lamp case screw
4
Lift the lamp up from the projector.
bottom
Insert the new lamp gently into the correct position.
6
Push the lamp bottom to check if it is correctly
installed.
Close the lamp cover and install the screws from
8
step 2 to install the cover.
(If the lamp cover is not installed correctly the unit will not
power on.)
Information
Knob
33