Table of Contents
Advertisement
ADJUSTING LOWER THRUST ROLLER
1 . To be sure the thrust roller is properly supporting
the blade, turn the thrust roller adjustment screw
using 5/32" hex wrench so that the roller moves
toward the blade and almost touches .
2 . While turning the upper wheel clockwise by hand,
adjust the thrust roller until it barely touches the
blade .
3 . Run the lock nut down finger tight, and tighten
with a 1/2" socket and extension .
4 . Rotate WHEEL (2) CLOCKWISE a few times by
hand and check the blade guides and thrust rollers.
Make readjustment if necessary .
Adjustments
ADJUSTING LOWER BLADE GUIDES
1 . Loosen the two Phillips screws that lock the lower
blade guides and press the two guides evenly
against the sides of the blade but do not pinch the
blade . Release the guides and rotate the upper
wheel slightly clockwise moving the blade down-
ward . Make sure one guide is not farther away
from the blade than the other and securely tighten
phillips screws .
Page 1 2
THRUST
ROLLER
INTERNAL HEX
THRUST ROLLER
ADJUSTMENT SCREW
ADJUSTING UPPER BLADE GUIDE ASSEMBLY
NOTE : The upper and lower blade guides support the
blade and keep it from twisting during operation . An
adjustment is necessary when blades are changed or
replaced.
1 . Loosen two hex head screws in upper blade guide
assembly and slide assembly forward in the slots
until the front edge of the blade guides are approxi-
mately 1/32" from the GULLET of the saw blade .
2 . Tighten two hex head screws while keeping the
blade guide assembly parallel to the table.
NOTE : It may be necessary to back out thrust roller
adjustment to allow thrust roller to move back from
blade to get 1/32" clearance from the gullet to edge
of blade guide.
BLADE GUIDE LIP SHOULD
AWAYS FACE THE BLADE
GUIDE ASSEMBLY
OAF
Hide quick links:
Advertisement
Table of Contents
