3.
Remove the RJ-11 connector cable from the clips and routing channel (2) built into the base
enclosure.
4.
Remove the RJ-11 connector cable from the base enclosure.
Reverse this procedure to install the RJ-11 connector cable.
ExpressCard assembly
Description
ExpressCard assembly
Before removing the ExpressCard assembly, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4.
Remove the battery (see
5.
Remove the following components:
a.
Hard drive (see
b.
Optical drive (see
c.
Keyboard (see
d.
Switch cover (see
e.
Display assembly (see
f.
Top cover (see
g.
Fan (see
94
Chapter 4 Removal and replacement procedures
Battery on page
Hard drive on page
Optical drive on page
Keyboard on page
Switch cover on page
Display assembly on page
Top cover on page
Fan on page
81)
45).
51)
47)
61)
66)
69)
76)
Spare part number
495085-001