Solid-State Drive - HP SpectreXT Maintenance And Service Manual

Solid-state drive

Description
256-GB
128-GB
32-GB
Before removing the solid-state drive, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see
5. Disconnect the battery cable from the system board (see
Remove the solid-state drive:
1. Remove the two Phillips PM2.0×4.5 screws (1) that secure the solid-state drive to the top cover.
(The solid-state drive tilts up.)
2. Remove the solid-state drive (3) by pulling the drive away from the slot at an angle.
Reverse this procedure to install the solid-state drive.
40 Chapter 4 Removal and replacement procedures
Bottom cover on page 33).
Spare part number
700813-001
700812-001
700811-001
Battery on page 35).