Table of Contents
Advertisement
Installing a 3.5" Hard Drive to the Hard Drive Carrier
1. Place the 3.5" HDD into the carrier with the printed circuit board side facing down.
Carefully align the mounting holes in the hard drive and the carrier.
2. Secure the hard drive using the four screws.
3. Place the hard drive carrier on the base plate with the thumb screw facing the front of the
chassis.
4. Align the keyhole openings on the base with the locating pins on the bottom of the
hard drive carrier. Pull the hard drive carrier toward the rear of the chassis until the
carrier clips.
5. Tighten the thumb screw on the carrier to secure the hard drive carrier to the base
plate.
1
13
2
4
5
3
Advertisement
Table of Contents
