Connecting Devices To The Switch - D-Link DES-3326SRM - Switch - Stackable Product Manual

Unit ID Display for Switches in a Switch Stack
The Stack ID 7-segment LED (as shown below) on the front panel of the stacking module displays the logical STACK NO.
The Master Switch in the stack will display STACK NO. 1. The remaining slaves display the STACK NO. 2 to 13 according
to the position in the logical stack order.

Connecting Devices to the Switch

These connections can be accomplished at any port in either straight-through cable or a crossover cable because the switch
supports Auto-MDIX function.
NOTE: Auto-MDIX function is not supported by the 100BASE-TX module.
•
A 10BASE-T hub or switch can be connected to the switch via a two-pair Category 3, 4 or 5 UTP/STP cable.
•
A 100BASE-TX hub or switch can be connected to the switch via a two-pair Category 5 UTP cable.
•
A 1000BASE-T connections use two-pair Category 5e UTP cable.
D-Link DES-3326S Layer 3 Switch
Figure 2 - 11. DES-3326S Stacking Module Front Panel
NOTICE: Spanning Tree Protocol is disabled by default on the Switch.
Keep this in mind when connecting the Switch to the network.
29