Sony DNW-7 Maintenance Manual page 58

3-1. Setup Menu
Viewfinder screen (Factory default setting)
* ENC ADJ. *
BURST START : 0
BURST STOP : 0
R-Y CAR. BAL. : 0
B-Y CAR. BAL. : 0
SYNC START : 0
SYNC STOP : 0
INT FSC FREQ. : 0
* DATA RESET *
USER
ENGINEER
* MENU SELECT 1 *
MARKER 1/2 : ON
MARKER 2/2 : OFF
VF DISP. 1/2 : ON
VF DISP. 2/2 : ON
MASTER GAIN : ON
SHOT ID : ON
SHOT DATA DISP. : ON
SHUTTER SPEED : OFF
! LED : OFF
SETUP CARD : ON
* MENU SELECT 2 *
VF SETTING : OFF
LEVEL -1 : OFF
LEVEL -2 : OFF
LEVEL -3 : OFF
LEVEL -4 : OFF
LEVEL -5 : OFF
LEVEL -6 : OFF
LEVEL -7 : OFF
LEVEL -8 : OFF
LEVEL -9 : OFF
3-14
Description
........... Adjusts the burst start position.
........... Adjusts the burst end position.
........... Adjusts the carrier balance of encoder.
........... Adjusts the carrier balance of encoder.
........... Adjusts the start position of the synchronizing signal.
........... Adjusts the end position of the synchronizing signal.
........... Adjusts the fsc frequency.
Resets the set value or adjustment value in each mode.
........... Resets the data set in the USER mode.
........... Resets the data set in the USER and ENG modes.
n
The adjustment data of the white balance and black balance are cleared in
each reset mode. The TEST OUT output is set to ENC. The TEST SAW is
canceled and the camera picture is output.
Sets whether to display the pages on the left in the USER mode.
Sets whether to display the pages on the left in the USER mode.
DNW-7/90/90WS