Disable Dcb; Configure Out Of Band (Oob) Management Port; Http And Telnet Authentication; Configure Login Credentials - Dell Networking N4000 Series Configuration Manual

Would you like to run the setup wizard (you must answer this question within 60
seconds)? [Y/N] N
2.3

Disable DCB

Note: If you plan to configure DCB (using Section 3) skip this section. For non-DCB environments, DCB
must be manually disabled using the following steps:
console>enable
console#configure
console(config)#no dcb enable
console(config)#exit
2.4

Configure out of band (OOB) management port

console>enable
console>#configure
console(config)#interface out-of-band
console(config-if)#ip address ipaddress mask gateway
console(config-if)#exit
2.5

Http and Telnet authentication

console>enable
console#config
console(config)#line telnet
console(config-telnet)#login authentication default
console(config-telnet)#exit
console(config)#ip http authentication local
2.6

Configure login credentials

console(config)#username admin password yourpassword privilege 15
console(config)#enable password yourpassword
9 SCG1001 Dell Networking N4000 Series and Dell PowerConnect 8100 Series Configuration Guide