Configure Ets Values; Save Configuration - Dell Networking N4000 Series Configuration Manual

console(config-if)#exit
console(config)#interface range fortygigabitethernet 1/0/1-2
Note: Port numbering for the 40Gb QSFP ports may vary by switch model and module configuration.
Confirm the correct port range for your configuration.
console(config-if)#datacenter-bridging
console(config-if-dcb)#priority-flow-control mode on
console(config-if-dcb)#priority-flow-control priority 4 no-drop
console(config-if-dcb)#exit
console(config-if)#switchport mode trunk
console(config-if)#exit
console(config)#interface port-channel 1
console(config-if-Po1)#switchport mode trunk
console(config-if-Po1)#exit
3.5

Configure ETS values

console(config)#traffic-class-group weight 50 50 0
Note: This command uses an example of 50% non-iSCSI traffic (first parameter) and 50% iSCSI traffic
(second parameter). The sum of the bandwidth-percentages must be equal to 100.
console(config)#exit
3.6

Save configuration

console# copy running-config startup-config
This operation may take a few minutes.
Management interfaces will not be available during this time.
Are you sure you want to save? (y/n)y
13 SCG1001 Dell Networking N4000 Series and Dell PowerConnect 8100 Series Configuration Guide