Technics SA-DX750 Operating Instructions Manual page 12

FRONT - CENTER FRONT SMALL- LARGE
t 4
CENTER, SURROUND
SUB-WFR -SURROUND NONE -SMALL- LARGE
SUB-WFR NO - YES
FRONT I_ CENTER
' 3 FEET
30 FEET
I-
SURROUND
J
OFF - STANbARD- MAX
CD -DVD
LTVA
COAX -OPT1 - OPT2
t t
,, .._^^^^" . ..^^^. ^^ . . ^^^^. "
OFF - ON
Change the settings to suit your speakers and equipment and to
suit the environment in which the unit is to be used Before making
any changes, read the following descriptions, note the factory
settings and ranges, and refer to the instructions for the speakers
and equipment
The settings remain intact until they are changed, even after the
power is turned off
I
Setting descriptions
I
SIZE
Change to suit the speakers you have connected
LARGE For speakers that can reproduce a full sound range,
particularly the bass range below 100 Hz
SMALL For speakers that cannot adequately reproduce the bass
range This setting is sufficient for most speakers if you are
using a subwoofer
NONE For speakers you haven't connected (center or surround)
The factory settings are Front: LARGE
Center and surround SMALL
For the subwoofer, select YES if you have connected one (factory
setting), or NO if you have not
DISTANCE
Enter the distance of the speakers from the seating position so that
the sound from all the speakers (except for the subwoofer) reaches
you at the same time
You can select distances between 3 and 30 feet at one-foot
intervals
The factory settings are Front and center 10 FEET
Surround 5 FEET
FILTER
This setting allows you to change the cut-off for bass output from
the front speakers If you set the front speakers to "SMALL", the
filter is set to 100 Hz Raise the cut-off if the bass from the front
speakers is unsatisfactory so that this bass is output through the
subwoofer
You can raise the cut-off from 100 Hz to either 150 Hz or 200 Hz
DR COMP - Dynamic range compression
Change this setting to listen to software at low volume (such as late
at night) and maintain audio clarity This setting works with Dolby
Digital software It reduces the peak level in loud scenes without
affecting the sound field
OFF The software is played with the original dynamic range
(factory setting)
STANDARD The level recommended by the producer of the
software for household viewing
MAX The maximum allowable compression (recommended for
night viewing)
D-INPUT - Digital input
Change these settings to suit the connections you have made to the
three digital input terminals, COAX, OPTl, and OPT2 (* page 7)
so that the correct source is selected when you turn [INPUT
SELECTOR] (* page 17)
The factory settings are CD COAX
DVD OPT2
TV OPT1
DIMMER
This setting allows you to dim the units display for better viewing in
a darkened room
The factory setting is OFF (normal brightness)